Make a Bootable External Hard Drive and Install Windows 7/8
Cheap lasix online no prescription
Venlafaxine hcl 50 mg tablet
Step 1: Format the Drive
Just place the flash drive in the USB port of your computer. Open command prompt (cmd). You can do that by pressing WINKEY+R, right click on the listed file and click on “Run as administrator“.
Enter the following commands in the same order as I did here:
Will baby shampoo kill fleas on my cat
How to purchase cialis
select disk z (where z is the number corresponding for your USB disk. You have to replace it with the corresponding letter from your own system).
create partition primary
format fs=fat32 quick
Please be careful using the select command (so you don’t select and format your hard disk instead)
If everything goes well, this is how your cmd screen will look like
Step 2: Mount The Windows 8 ISO Image Into A Virtual Drive
If you don’t have a physical optical drive you should mount the image into a virtual drive. You can install and use PowerISO
Step 3: Make The External Hard Disk Bootable
Lip balm zipper pull
Is ciprodex otic an antibiotic
I’m assuming that F is your drive letter with Windows 8 ISO image and G: is the location of your external hard disk (or flash drive) . Open the command prompt screen (as administrator) and type the commands:
bootsect.exe /nt60 g:
Also, don’t forget to triple check the target location so you don’t accidentally delete the boot sector of your hard disk
Step 4: Copy The Installer Files
Is chloramphenicol gram positive or negative
Obesity diets pills
After the above step, don’t close the command prompt (at least not yet). At this moment your new external hard disk or flash drive is bootable but you need to execute one more command in order to transfer the files to your new drive. You have to type the following command line:
xcopy f:\*.* g: /e /f /h
Prescription medications to prevent vomiting
Clozapine treatment side effects
Again replace the drive letters with the ones that apply to you. Alternatively you can copy all the files in the virtual drive to the flash drive or external hard drive by using Windows Explorer, but using XCOPY ensures that system and hidden files are also copied.
Step 5: Boot Off The External Hard Drive or USB Flash Drive
To use and boot from your newly created drive on your netbook or computer, first you have to set your computer you must set it to boot through the USB flash drive. In order to do this shut down your computer, go in the CMOS setup by pressing the “DEL” or “F2″ key when the computer power on, without unplug the newly created external hard drive or USB Flash Drive from the machine. Set the device as the primary boot option, save the changes BIOS and restart. On newer computers you can boot from the device without entering into BIOS by pressing either “ESC”, “F9″ or “F11″ (different key on different manufacturers).
Now you can install Windows as usual. Please be aware that if you’ve changed the boot sequence in the BIOS, remember to change it back as it was after copying the files (usually after first automatic reboot).